Giving the Finger - Mini Flip Middle Finger Keychain Another one of those designs that I have been meaning to print for ages and printed as part of the November Print Event https://www.crealitycloud.com/contest/november-3d-printing-event. Great PIP (print in place) design by [%6998343023]and designed to be very simple to print on any FDM printer without supports. This was a good test for the Creality Hyper PLA filament and the K1 to see how fast I could print it and have a useable print at the end of it. Printed in minutes and worked a treat. When you take it off the print bed don't force the mechanism as the finger will fall out. Gently easy the finger up and down (errrrr) and it will work fine. You can also use this design as a tolerance test for tweaking your printer. Printed on my K1 Max in Creality Hyper Series Red PLA, sliced on Creality Print with 100% infill and no supports needed. I managed to print the one shown with the speed set at 200mm/s. [%9631304319][%6839402488][%2443000667]