How to organize your desk in wild west:Print is constituted of 8 parts,1- platform ( its the base) printed in PETG2- Post ( the T shaped post on the back) printed in PETG3- Rings ( the chain rings holding the banners) printed in Silk PLA4- Plates ( the back ground of banners, there are 2set, 1 set is empty, 1 set is falconsson engraved) printed in Silk PLA5- Falconsson Logo ( print the empty plates and glue your own banner on them, this is just for falconsson banner) printed in Silk PLA6- Whiskey Barrel ( i think its obvious) printed in PETG7-ExplosiveCrate (its the SD card & flash drive organiser in the middle) printed in PETG8- Wanted Photo Frame: ( i guess this is also obvious) printed in silk PLA.all parts well aligned for slicer software, you dont need to flip anything.None of the parts require support, print bed adhesion only maybe needed for rings, other parts holds well on the build plate.Actually printing and assembly processes were effortless, painting / make up procress was fun to make. As result i have a very unique organiser on my desktop. I hope you enjoy this as much as me.[%1786422819]