I’ve always had a soft spot for mesh style 3d models, but this one caught my eye and it looked as if it was going to be a challenge to print. The original print file was optimized for the Ender 3 Neo yet I printed it on the Ender 3 V3 SE, causing me to change some settings in orca slicer such as the speed. The Ender 3 V3 SE is marginally faster than the Neo so the print speed was bumped up to 100mm/s for overall speed which is slower than the normal speed for the V3 SE, this allowed for better looking overhangs. The travel speed was also upped to 200mm/s so it wouldn’t mess up parts. Smaller parts in the first layers had a hard time adhering reliably so a brim of 10 was added. I printed in Ender PLA White to give off the aesthetic of the skull. After printing, you can use a sharp object or pliers to remove the brim (edges may need sanding). Happy Printing! Thanks[%5594063233]for the file!