Hatsune Miku is one of my daughter’s favourite characters so I have attempted to print several of the available models. They are always challenging. In this case the results are not too bad, but some way off ideal.The printer is a Creality Ender-3 V3 SE, using SUNLU Transparent PLA. I used Cura 5.6.0 to slice with 20% infill and tree supports. The supports were tricky to remove as the hair in the model is also very thin. In the end they did all come off without breaking any of the model, though the head is a bit wobbly!There is definitely scope for improvement, and the model may work better when scaled up.Thank you [%2066446286]for supplying the challenge.