Hello ! I've released a poop chute for the K2PRO and am waiting for feedback :) If you have some filament to waste (and a K2PRO), waste it on mine :P ! Redirects CFS purge (“poop”) to the front of the K2 PRO for easy clean-up. Tight mechanical slack by design; a light sandpaper pass may be needed. Default right-side install; mirror in slicer for left. Includes three optional mini bins (S/M/L) to catch waste, pick the size that fits your setup. Thermal & airflow note The chute angle was computed to be as steep as possible without obstructing the PSU ventilation. Blocking that vent can raise local temps and soften PLA over time. Flow behavior note Because the chute prioritizes steep angle without covering the PSU vent, a few small purges may occasionally pause partway down instead of falling straight into the bin. They typically drop within a few minutes due to printer vibrations or when the next purge nudges them (inertia restart). Print recommendations Chute parts: PLA; 0.2mm layers max ; supports only for part2. Bins: PLA or PETG work fine; 0.28 mm layers; 2–3 walls; 15–20% infill. (Bins are not near the PSU vent; choose PETG if your enclosure runs warm.) Assembly (see Tutorial photos) 1. Mount Part 1 in place (both screws). 2. Seat Part 1 onto Part 2 with a slight angle (intentional assembly tilt), then level and slide fully home. 3. Insert Part 3 and reuse the existing screw to lock Part 3 (do not over-torque). 4. Place one of the bins beneath the chute outlet. Fit note Interfaces are intentionally tight. You may need a quick sandpaper pass on the mating tabs/slots, only on the contact areas. Left-side install Right side is default. For left: Right-click → Mirror in your slicer; screw locations are symmetric. Need an update/fix ? Feel free to ask ! :)