The Club is about 1550 mm long and is split into two parts to fit an Ender 3. The hollow parts range from part 1 to 6. (they have the "H" in the name, Parts 7 and 8 are to be used in both versions.

- The Hollow version:

It has 14.40mm and 4,30 holes to be able to place 14 mm wood or aluminum rods and 4 mm aluminium rods as a skeleton. - The not Hollow version:

It has 14.40mm holes to be able to place 14 mm wood or aluminum rod as a skeleton.

I recommend aluminum. With aluminum rods it is more resistant, but the final decision is up to you.

From personal experience, printed rods end up breaking easily. That way, you can use a 4mm aluminum rod (it can be circular or square. The hole is square, but 4 mm rods will fit.)

For a PLA printer advice these settings

Quality: 2.8

Walls: 2 or 3

Infill: 10%

Pattern: Zig Zag

- Part 8 may need some small supports.

-I don't like to make vertical cuts because the circular parts never look good ( in my opinion. ) But this wand is quite difficult to print in height. Therefore, I also make available a horizontally sliced version

- I recently discovered a new feature in the program I use, so all parts were exported in high definition.

If you liked the model, please click on like and rate. It is very important for me to know that they like my models. If you have any suggestion or doubt, do not hesitate to ask. :)

You can whenever you need to send me a message here or on my Instagram. @Titi_Cosplay

Luck on the Printing and happy cosplay! :D

Takeru ( Yamato kanabo club ) - One Piece