3D model description

MULTI SIDED CUBE for kiddies for playdough and sensory play.

The cube measures 40mm square.

The pictures are debossed with different depths between 1mm to 1.6mm.

They are all chamfered to perfection in and outside the images for flawless printing.

Included on the cube are:

• Six Peppa Pig characters

3D printing settings

One of the images would have to be at the bottom. I would choose the side that would have the smallest area to either bridge or add supports.

If you do choose supports – make sure that you choose as little as possible – as it can be hard to remove.

I use Cura (CREALITY) and Flashprint (FLASHFORGE) slicers:

• No less than 3 wall widths of 0.4mm

• 4 Top layers.

• No less than 10% Lines or zig zag infill.

• A strong infill would be Gyroid.

• Use variable layer heights with a base of 0.2mm layer height

• Slower printing always equals a good quality print. (Unless you are spoilt with a fast-printer!

• Follow the instructions of the filament producer for heat settings.

• I use PLA and the longevity and strength is just fine.

PLEASE NOTE THAT ALL MY MODELS ARE FOR PRIVATE USE ONLY! PLEASE CONTACT ME IF YOU WOULD LIKE A LICENCE TO SELL.

Educational PEPPA PIG for playdough and sensory play