Warning: Those without mechanical skills and knowledge should not purchase this model.

This model has been shared here only after ensuring it is working

BirdBath-05 needs support but not touching build plate. otherwise, the water channel will be blocked by the support, and water flow will be interrupted.Your bird bath will not work.

I designed a bird bath for my budgies.

The design has a shower feature. Normally I could buy a ready-made water pump and attach it, but I designed the pump part to be printable to show what we can do with a 3D printer. My motor works with 1 AAA size battery. I also added the part design STL file for your motor that can be attached with 2 AAA size batteries.

Cleaner with a large water tank

Long-lasting use is aimed with the motor design above the water level

A shallow water level for your birds

You will need

wire,

motor (1.5-3V),

on-off switch(9x13mm mini switch),

battery spring

1 or 2 batteries (AAA size)

Assembly instructions:

Install the motor shaft

Install the motor

Install the on-off switch, battery and motor wires (motor rotation direction CCW)

You can use a small amount of liquid gasket when assembling birdbath-01 and birdbath-05.

Do not use fast adhesive to disassemble if necessary.

insert battery, attach battery cover, fill with water

AND

enjoy watching your budgies have fun

Attention:check and adjust the axis carefully when attaching the shaft to the motor. otherwise it may make noise.

printed with Ender3v2

ABS %35 infill 50mm/s

240°C degree hotend

100°C bed heat

The parts were designed in the position they should be printed. You don't need to change direction.

BirdBath-01 needs support

BirdBath-02 needs support

BirdBath-03 needs support

BirdBath-04 not need support

BirdBath-05 needs support but not touching build plate (Please reread the red marked notes at the top of this information)

BirdBath-06 needs support

Bird Bath With Shower