Creality K1 Max - Deluxe Top Lid Riser. With custom Front Text.

It will get a rail for LED and a optional TPU Spool Holder, that i´m currently working on, along with other accessories later.

I wanted to make the most stable vibration-free riser possible, and also wanted it to match my feet.

I did consider vents but decided against it, as in my experience, they are not enough, and I need to remove the glass lid, when printing lower temp materials (I may make a V.2. with vents, at a later point).

*Raises the glass plate 45mm.

*Locks on, rather than just stand on top, so nothing moves.

*Very sturdy, minimal vibration in riser and glass plate.

*Held together with Custom Thumb Screws.

*Grove for 8mm LED Strip all around, and a slot in the back, to run the strip through (There is a plug for the hole, if not used).

There is also screw holes on the back, so LED wired can be mounted with clips.

I used a cheap 2M Bluetooth controlled, USB powered, LED Strip from Ali Express, and use the printers own usb port for power, so it turns on with the printer.

*The front and the Back, have 2x M3 Screw Holes (they have no specific purpose at this point, but I put them there, just in case i needed to add to it).

*It will get a optional TPU Spool Holder, that can be easily mounted with thumb screws. (I´m almost done with it, and will upload it as soon as i´m done/satisfied).

Printed in ****** Rapid PETG.

For the Riser I used just under 640g filament.

I uploaded the Front, with my text, and a version with no text.If you want a specific name on it, let me know, and I will upload it for you.

With a single color setup, it will take 6 filament changes, to print it with a different color text.

Riser - Parts List (with settings used):

1x Front.

0.2mm, 4 Walls, 10% Infill.

Support. "Snug" with 5% "Threshold Angle", "Build Plate Only".

1x Back.

0.2mm, 4 Walls, 10% Infill.

Support. "Snug" with 5% "Threshold Angle". "Build Plate Only".

1x Left Side.

0.2mm, 4 Walls, 10% Infill.

Support. "Snug" with 5% "Threshold Angle", "Build Plate Only"

1x Right Side.

0.2mm, 4 Walls, 10% Infill.

Support. "Snug" with 5% "Threshold Angle", "Build Plate Only"

4x Corners.

0.2mm, 4 Walls, 20% Infill.

Support. "Snug" with 5% "Threshold Angle".

8x Riser - Thumb Screws.

0.2mm, 4 Walls, 100% Infill.

1x LED Hole Plug (Optional).

0.2mm, 4 Walls, 100% Infill.

REMEMBER TO CALIBRATE INPUT SHAPER AFTER INSTALLATION...

PURELY FOR PERSONAL USE, AND IS NOT TO BE REMIXED, SHARED, MADE FOR OTHERS OR USED COMMERCIALLY...

Only those ho paid for it, should have access to it, thereby keeping its exclusivity...

Contact me, if you have other suggestions...