It's Easter and many eagles need an eggshell to protect themselves

The case is specially designed for the Dji mini 2 drone, so that it takes up as little space as possible in your pocket or backpack and is smooth without sharp corners. The casing protects the sensitive propellers so that they are not under pressure. The design is also specially designed for small printers with a working area of 120x120x120mm, and therefore the print is 2 parts, connected by Velcro tape. You also need two pieces of foam for the inner padding.

Box contain USB card reader slot and 2 slots for SD cards. Also there is flat area inside the box where you can print duplication of idendify label for drone or drone pilot licence so it will be always with you when you traveling.

Additional material

Foam

Bottom Box foam thickness 6-10mm 60x40mm

Top Box foam thickness 6-10mm 45x10mm

Velcro stripe

Soft side stripe 20x1mm Lenght 250mm

Hook side stripe 20x1mm Lenght 300mm

You can use Creality Slicer but you can find K-Max gcode version also here. Design is generated so it does not need any support material. Only for Box Top part i suggest to use 5mm skirt for better adhesion against the printbed.

You can use normal PLA, latest model was printed out Hyper PLA . Useing 40-60% infill is strong enough to keep your drone safe in your backbag. (tested)

DJI Mini 2 Drone Eggshell Case