Door-Mounted Coat & Accessory Hanger – 20 cm

This door coat hanger is a minimalist, modern solution for organizing everyday items without drilling, screws, or permanent installation. Designed to hang securely over standard doors, it combines a strong vertical spine with multiple forward-facing hooks, offering high capacity in a compact footprint.

Key Features

Optimized Door Hook Geometry

The rear door hanger is designed with a precise 87-degree curve, allowing it to sit firmly over the top edge of the door while maintaining clearance for smooth door operation. The angle provides a snug fit that resists wobbling or accidental lift when loading or unloading items.

Compact Yet Spacious Design

With a total height of 20 cm, the hanger maximizes vertical space while remaining discreet. Ideal for doors in bedrooms, bathrooms, offices, or closets.

Multi-Hook Layout

The front features four evenly spaced hooks, each shaped with a gentle upward curve to prevent items from slipping off. This configuration allows you to hang:

Coats and jackets

Bags and backpacks

Hats, scarves, belts

Headphones, cables, or accessories

Structural Reinforcement

Subtle triangular cut-outs along the spine reduce material usage while improving rigidity and print efficiency. The flowing, continuous curves distribute load evenly across the structure, increasing durability even when fully loaded.

Print-Friendly Geometry

Designed with smooth transitions and consistent wall thickness, making it suitable for clean FDM printing. No complex overhangs on the hooks themselves, resulting in strong layer adhesion where it matters most.

Modern Aesthetic

The sleek, sculpted profile looks intentional rather than purely functional. It blends well with modern interiors and doesn’t look out of place on visible doors.

Printing Notes

Recommended materials: PLA, PETG, or ABS

Print orientation: Vertical as modeled for maximum hook strength

Infill: 20–30% (increase if planning to hang heavier items)

Supports: Not required in most slicers