-filament guide that utilizes m6 push connect fittings for ender 3 v3 ke/se

-i made this to make it easier and faster to swap filaments during a print or when needing to change filaments when running from a dry box or filament dryer

-i have included a tall version which is approx 106mm and a short version @ 75mm tall

-included photos are of tall version although the short version is probably more practical for most people

-both heights have three different options to choose from. single, dual, and quad.

-the single and dual versions for both tall and short have a tab that can be used for mounting your filament runout sensor in a similar location to the original mounting location.

- the quad version does not have the mount tab built into it

-these mount to the same mounting points as the original spool holder that comes on the machine on the top of the gantry so can only be used if you have moved your spool holder from the top of the printer.

-single and dual versionscan be printed without supports when printed on their side with the runout sensor mount tab down against the build plate. the quad version needs supports and to be face down on the plate all should be in correct orientation when you load them into your slicer. if you keep the orientation and use supports as described the print will turn out very nice with little to no scarring for the quad version and the supports should remove very easily.

-the photos are of the tall version although im pretty sure the shorter version will be more practical and preferred among most people

-the multi fitting versions allow you to run other filaments or colors to help make filament changes between prints easier and faster or to do manual changes in the middle of a print for manual color changes. these are very sturdy and shoukdnt have much, if any flex and will hold up very well over time.

-if using inside an enclosure i would recommend printing with something that has some heat resistance like PETG, AbS, or ASA. PLA should be ok if printer is not inside of an enclosure.

-hope some of you find this useful! if you like the model, hate it, or have any suggestions to improve it consider posting your make or a comment and let me know!

Ender 3 V3 ke/se m6 ptfe guide (single,dual & quad versions)

0.2mm layer, 2 walls, 15% infill