I am mounting more HSW tiles on my wall, and wanted to mix screws and command strips since each screw drills out a portion of my security deposit. I had trouble finding any models that attached the HSW on the top/bottom with command strips that will let it sit flush on the wall.

I designed this one quickly to do this.

Using slicer modifiers, I also added 4 6x3mm magnet embedded on the other side of the command strip for the hell of it (I figure maybe I'll have some metal I want to put on it, who knows?).

If you want to try this as well, add 4 negative modifier cylinders equally spaced in the command strip portion of the wall mount. Each should be the magnet diameter by its height plus a bit extra for inserting the magnets and tolerances; I did 6.2mmx3.2mm. Have them start at around 0.4mm height (2 layers). I included a picture showing the placement (hard to do since they are inside the base).

Print Settings:

4 Walls

30-35% infill (I used a modifier to go 10-15% on the command strip portion)

Layers: 0.20mm

Line Width: Shouldn't matter

This is a remix of 2 models:

Honeycomb Storage Wall by RostaP - https://www.**********.com/model/152592-honeycomb-storage-wall

Rotated Longer Command Strip holder for Honeycomb Wall - https://www.**********.com/model/424650-rotated-longer-command-strip-holder-for-honeycomb-

HSW - Command Strip Wall Mount For Top/Bottom

0.2mm layer, 4 walls, 30% infill

0.2mm layer, 2 walls, 15% infill