Needed an LED Light solution for my K2 Plus

There were a limited number of files to choose from, and most were either limited or had few instructions, so I decided to use a concept created by @DIYAnanas and FYSETC Ltd.

Used my Raptor Scanner to scan around the top to get locations of the castings after removing them from the printer to get a better layout.

There are only 3 parts to print

No need to remove the PCBs on the upper right-hand side; the part fits snugly without hardware, and the cover can be replaced (photo)

only requires 7 screws and a couple of drops of silicone glue.

Parts Needed

24v COB LED Strip,. https://a.co/d/0agaSEy0

7 M3x12mm screws

if you make your own you will need 8mm wide or less, and able to handle the heat of the chamber (for my application, 2 pcs (850mm and 400mm) can be slid in from the end or folded into the bracket after installation

24ga wire

Connectors, if you choose to make it removable

Shrink tubing

A small amount of silicone (to make sure the parts stay in place

Ability to solder

Parts printed with ASA and PETG filament

K2 Plus LED Lighting Redesign

0.2mm layer, 2 walls, 15% infill, ASA w/PETG Support interfa