This Planet Wand is Sailor Pluto's Transformer.

Is the version featured in the 90s anime.

The wand is about 300 mm long and is split into two parts to fit an Ender 3.

It has a hole in the middle so you can put a stick as a skeleton.

I also provide a rod, but if you want to place an aluminum rod.

From personal experience, printed rods end up breaking easily. That way, you can use a 4mm aluminum rod (it can be circular or square. The hole is square, but 4 mm rods will fit.)

For a PLA printer advice these settings:

Quality: 2.0

Walls: 2 or 3

Infill: 10%

Pattern: Zig Zag

- Part 1 will need suports.

-I don't like to make vertical cuts because the circular parts never look good ( in my opinion. ) But this wand is quite difficult to print in height. Therefore, I also make available a horizontally sliced version

- I recently discovered a new feature in the program I use, so all parts were exported in high definition.

If you liked the model, please click on like and rate. It is very important for me to know that they like my models. If you have any suggestion or doubt, do not hesitate to ask. :)

You can whenever you need to send me a message here or on my Instagram. @3d.titi

Luck on the Printing and happy cosplay! :D

Pluto Planet Wand Tranformation - Sailor Moon