This cable holder was designed with simplicity and strength in mind. Its clean geometry ensures compatibility even with lower-end 3D printers, while the robust structure withstands the tension caused by mounted cables. The part can be easily fixed to walls or surfaces using screws or nails, making it ideal for cable management in workshops, homes, or DIY electronics setups.

No assembly is required — it's a single-piece print that’s ready to use straight off the bed.

📐 Dimensions

📏 Length: 21 mm

📐 Width: 10 mm

📦 Height: 10 mm

⚙️ Print Settings

🖨️ Printer: Creality K1 Max

⏱️ Print Time: ~6 minutes 56 seconds per piece

📏 Layer Height: 0.2 mm

🧱 Infill: 100% (solid for maximum durability)

🧩 Supports: Not required at default size

🧵 Material: PLA or PETG recommended

🛠️ Assembly: None — print and use

⚠️ Important Note

If you scale up the model — especially the hole diameter — support structures may be required! Larger overhangs around the mounting hole can lead to poor print quality without support.

Cable Holder

0.2mm layer, 2 walls, 100% infill