I made this design to fit inside a tool briefcase that i bought just for this.

The tool briefcase dimensions are (according to the seller) 46x33x15.2cm (metric system, NOT inches).

The 3mf file contains every part and states how many of each part should be printed.

Each column can hold 500 sleeved cards no problem (dark ages goes from top to bottom alone)

I made the dividers in PETG but can be printed in PLA.

Everything else i made it in PLA.

This is a work in progress as i still need to name every divider after the card that it holds.

Hope it works for you too

Inside the box there is:

-Dominion base game 2nd edition

-Intrige 2nd edition

-Seaside 1st edition (with embargo tokens)

-Renaissance

-Dark ages

and there is still room for a couple more expansions.

The token boxes that can be seen in the pictures are Zachrandir designs which are not uploaded here.

This boxes are sized same as regular cards. so they fit perfectly in this organizer

Here you can see the card stopper. This is to separate base cards from base game without cards falling when you take out the base cards. You can place it anywhere in the column and it will remain fixed there. Can be used anywhere you want to stop cards from falling or mixing.

Pay attention that there are two different sets of colums... this is because there is one that has a thicker side and thinner side.

The thicker side is 3mm thick and the thinner side is 1.5mm thick.

The other column tipe has two 1.5mm thick sides.

This is so that when you put them together they add up to 3mm.

3mm sides should be at the most left and right sides... and the 1.5mm version shoud be at the middle.

I do this for fun, but if you invite me a coffee i'll be delighted

Esto lo hago por diversión, pero estaré encantado si me invitas un café

https://buymeacoffee.com/scheimat

Dominion card storage organizer for briefcase

0.28mm layer, 2 walls, 15% infill

0.2mm layer, 2 walls, 15% infill