Hello! This is my Expandable Christmas Tree Snowflake. It expands from a Snowflake into a Christmas Tree! It is honestly pretty cool. Instructions for how to properly print it, put it together, and use it are below:

Instructions:

First: Print the "Christmas Tree Snowflake" model in green. At layer 115 (10 layers before it finishes), add a pause and switch to white. This will allow for a green Christmas tree, but also feature the white Snowflake.

---------------------------------------------------------------------------------------

Second: Print the "Base" and the "Stand" in white

----------------------------------------------------------------------------------------------------

Third: CAREFULLY put the Snowflake into the "Base." I recommend turning the snowflake upside down on a table and placing the base on top of it. It is a little tight. During this process, make sure the Snowflake doesn't fall apart. I am not 100% sure why, but the pieces are asymmetrical and will only fit properly - without sticking - one way. If they fall out, it may take a minute to find the right direction to put them back together.

-----------------------------------------------------------------------------------------

Fourth: Put the stand in the bottom of the base. Paint the star on top, and let it dry before removing the stand. Alternatively, if you have a multicolor printer, you could print the star in yellow from the get-go, but it wastes a lot of filament.

------------------------------------------------------------------------------------------

How to properly use your Expandable Snowflake:

If used improperly, it could be a pain putting the snowflake back together. I recommend lifting the snowflake straight up, off the stand, to prevent any pieces from falling into the base. If tilted sideways and slowly turned right-side up, the star WILL fall into the base and will be a pain to try and put back into place. Therefore, DO NOT DO THAT. Any other way of expanding or closing the snowflake should work just fine. Have fun!

Annual Designer Awards:

Btw, guys, I am in the 2025 Annual Designer Awards, and I would greatly appreciate it if you voted for me. But I urge you to vote for your favorite designers first. Obviously, I am one of your favorite designers, though, so it shouldn't be too hard to click that vote button 😂

https://m.crealitycloud.com/en/annual-designer-awards-2025/detail/7485051103

Expandable Christmas Tree Snowflake

Official Print Setting - Designed specifically for the K1C

0.2mm layer, 2 walls, 15% infill