This drawer is mounting under K2 Plus and gives you 8x8 gridfinity space (336x336x25.4mm).

My set of gridfinity boxes included, but you can prepare your own by any of gridfinity generators.

Using standard sliding rails with bearings, so moving smooth and silent;)

Drawer extends on a full depth, even on this partial travel rails.

Multicolor Creality and K2 Plus logos on the front panel you can reset to a single filament.

Can store up to six metal build plates (3x2) in any orientation. If you dont need stand for build plates, just mirror right base parts.

Printed with PLA. Use glue for a precision printing (i'm using eSun eGlue)!

Other parts to build:

1) Sliding rails L450mm H17mm - 1pair (i'm using Boyard DB1711Zn/450, but you can use almost any 450x17x10mm rails, it have two standards and i've add holes for both)

2) M4 5mm screw - 12pcs (i'm using DIN 7380 black color)(for rails and between rails and drawer)

3) M3 8mm screw - 2pcs (for handle)

4) M3 5mm screw - 2pcs (for front panel ends)

5) M4 5mm heat-set threaded insert - 2pcs (for rails front)

6) Rubber adhesive pads 35x35x2mm - 2pcs sqared and 4pcs round (i'm using Space Pi rubber pads after CFS mod)

7) Space Pi Plus handle - 1pcs (i'm using it after CFS mod, but i prepared the model, just print)

Assembly:

1) Check the place of screws with your rails and than melt in two inserts in the front base parts by a soldering iron

2) Assembly base parts with rails

3) Put this under the printer

4) Screw up the drawer to rails

5) Attach the front panel and the handle

6) Put in gridfinity boxes of your choice

K2 Plus drawer with build plates stand

PLA 0.2mm layer, 2 walls, 15% infill

0.08mm layer, 2 walls, 15% infill

0.2mm layer, 2 walls, 15% infill

Modèles modifiés