Best material:

Resin (Transparent or ABS-like Clear Resin) strongly recommended to replicate the organic, glass-like lattice appearance.

For FDM: Transparent PETG or Clear PLA+ to enhance light transmission and color blending.

Layer height:

FDM (Creality K1C): 0.12 mm for smoother organic transitions

0.08 mm for maximum surface refinement

Resin: 0.03–0.05 mm for ultra-smooth translucent finish

Supports:

Yes, required.

The flowing organic lattice contains multiple overhangs exceeding 45°.

FDM: Tree supports, touching build plate only, low density (8–12%).

Resin: Light supports on inner lower curves and underside of raised strand intersections.

Infill:

100% for wearable strength

25% for decorative scaling (gyroid recommended)

Walls:

4–5 perimeters to maintain structural integrity and improve translucent wall consistency.

Orientation:

Tilt 30–40° backward to reduce support marks on the most visible flowing strands and improve resin drainage if applicable.

Avoid printing fully vertical due to complex internal overlaps.

Scale Suggestions:

18–22 mm inner diameter → wearable organic ring

50–70 mm → artistic desk sculpture

100 mm → translucent modern art display

Prismatic Flow Nexus – Noah0x03Prismatic Flow Nexus – Noah0x