Here are some upgraded paddle tires for the Traxxas Slash.

My last design broke when I used them on packed snow and a few rocks, so I decided I would start with an entire new design. This time I made them a bit wider for more traction and to float a little better on snow.

Rim:

Filament: PLA is what I used

Infill: 15% or higher (15% worked well for me)

Support: Yes

Rotate 180 degrees for the cleanest print. Leave as is for minimal supports.

Rim Center:

Filament: PLA

Infill: 100%

Support Yes

Paddles:

Filament: TPU for best durability, other types may work as well

Infill: 100%

Support: Yes

Make sure they are rotated to have the lip faced down to reduce supports.

Assembly:

Screw the rim center to the rim itself using the screws as seen in the picture. Next, glue the paddles to the rim. For this you will want to put the lip of the paddles on the back side of the rim. Glue the rim as seen in the pictures. Put them together. Let it dry.

Please note: Using these may cause damage to you R/C or shoot rocks up at people or anything else.

I tested these using the Slash 2wd on a cheap 3s power system.

Please let me know if you have any questions or things I could improve on.

Slash Paddle Tires

0.2mm layer, 2 walls, 15% infill