Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 133.04x200mm in size

You may print at higher layer heights below the Base Thickness of 0.48mm

The Max allowed Thickness is 2.24mm and the Actual Thickness is 1.92mm

Filaments Used:

#000000 PLA+ Sunlu Black Transmission Distance: 0.6

#565d65 PLA+ Sunlu Grey Transmission Distance: 2

#d22332 PLA+ Sunlu Red Transmission Distance: 6

#ff8000 PLA+ Sunlu Orange Transmission Distance: 5

#ffffff PLA+ Sunlu White Transmission Distance: 5

This print uses 5 unique filaments

Swap Instructions:

Start with Black

At layer #9 (0.8mm) swap to Grey

At layer #11 (0.96mm) swap to Red

At layer #13 (1.12mm) swap to Orange

At layer #17 (1.44mm) swap to White for the rest.

Scaling Instructions

Resize as needed, but remember to reset the Z-axis to 100% before printing .

The .3mf file with black picture is with PAUSE, inserted for manual change of the filament.

The .3mf file with green picture is with auto filament change, for the CFS.

Wolf - HueForge