About

This is an adaptation of the FransKV "20mm LEFT Hinged Lid Riser for K1 and K1C (Perfect for CFS)" except I removed the Hinges, and added a recess to push 2x6mm magnets into place.

The magnets add a satisfying SNAP when closing the lid. It also assists in closing the lid because the lid sits snug on the riser (hence the perfect fit). Due to my setup, hinges would not work, so they were removed.

Requires:
4 x 20mm M3 Button Head screws (Also known as Cap Head screws).

8 x 2x6mm magnets.

Note - If you use 'socket head' screws, you may not have space for the magnets to sit relatively flush.

Make sure to use the 3MF. You can change the size of the "Negative Part" cylinders in order to increase the depth of the recess. But note, you will have to use shorter screws if you do so.

Print settings:

0.4mm nozzle

0.2mm layer height

Tree supports

3 walls

50% infill

Space Gray PLA

Warping: Warping WILL be an issue due to long thin walls with a lot of support so make sure to counter this by using a textured plate and/or glue. 100% adhesion is necessary.

Make sure to use the 3MF. You can change the size of the "Negative Part" cylinders in order to increase the depth of the recess. But note, you will have to use shorter screws if you do so.

Assembly:

You can assemble without glueing parts together. For a sturdy feel and a clean snap'n close, you should superglue it all together.

Do not overtighten your M3 screws. Lightly tighten and that's all you need.

Press your 2x6mm magnets into place.

20mm Lid Riser for K1 and K1C with magnets (Perfect for CFS)

0.2mm layer, 3 walls, 50% infill