Printed in Ender-PLA using a K1C. In this case, we will use the 0.20mm preset for the K1C. The print takes just over 25 minutes to complete. There is barely any room for infill, so it is up to you whether you go with the default infill settings, or lower values.

The following settings were changed in Creality Print from the default options.

Strength

AI Infill: Checked

Sparce infill pattern: Rectilinear

We want to make sure that the stand retains structural integrity when it is in use. This egg stand is a little bit on the thinner side. Therefore, we will let the AI help us out to provide support in an efficient manner. Rectilinear infill pattern was used since the AI is able to utilize it under 20% infill (The default is 15%, which we are using). The AI is only able to use grid infill pattern with infill densities of 20% or above.

Speed

First layer: 30 mm/s

First layer infill: 50 mm/s

Initial layer travel speed: 50%

This is the number of top interface layers: 4

By reducing the initial layer (the first four layers to be precise) print speed, we ensure that the first layer adheres optimally to the print bed.

Other

Brim type: No-brim

There are no bed adhesion concerns with this print.

Alien egg holder

0.2mm layer, 3 walls, 15% infill

0.2mm layer, 3 walls, 25 infill

0.2mm layer, 2 walls, 15% infill