This is a lightweight (inland basic pla), functional clamp-on remote holder designed specifically for thicker headboards up to about 1¼ inches (≈32 mm). The design prints quickly, uses minimal filament, and includes both left and right versions so you can mount it on either side of the bed.

Features

Efficient print:

The holder is optimized for strength while keeping material use low. It requires roughly 120 g of filament and prints in just under 5 hours on a standard 0.2 mm setup. No complex supports are needed.

Left and right modules included:

Both versions are provided so the clamp can be mounted on either side of the bed. Each version is fully functional and sized to match typical solid-wood headboards.

Large front access window:

The front opening is intentionally oversized. Many remotes can be used directly through the window without removing them from the holder, making it convenient for frequent use.

Adjustable threaded screws:

The printed screws are long enough to fully close over headboards up to approximately 1¼″ thick. They can be trimmed to length if you prefer a flush fit. The wide screw caps distribute pressure evenly and help prevent dents or scratches on the wood surface.

Holds two remotes:

The interior bay is wide enough to store two full-size remotes side by side, including TV, streaming, AC, and other common remote types.

Secure clamping force:

The clamp has been tested to hold up to about seven pounds without slipping. This provides a significant safety margin for daily use and ensures the holder stays firmly in place.

Fitment Information

Designed for headboards in the 1.0″ to 1¼″ range (approximately 25–32 mm).

Actual maximum clamp clearance is about 32.6 mm, but listing a conservative range ensures the best performance and avoids over-tightening on oversized boards.

Dual-Side Remote Holder – Headboard Clamp System

0.2mm layer, 2 walls, 15% infill