Updated version can be found HERE: https://www.crealitycloud.com/model-detail/game-board-marker-v4-1-scoring-post-for-cribbage?source=22

I needed to replace the plastic scoring pieces for my cribbage set. This turned out to be a rather difficult print as it is so small and the sidefan would blow the piece over. I ended up modeling a built-in support to help it and also turned the side fan speed to 50% to help reduce the blow over. The built in support snaps of easily and with a bit of fingernail sanding it comes out smooth!

I did have success one time printing version 1.0 in vase mode but it wasn't too good.

Best of luck printing!

AI thoughts...

Design Idea

https://www.crealitycloud.com/model-detail/game-board-marker-v4-1-scoring-post-for-cribbage?source=22

This scoring post is designed for use with games like cribbage where small markers are required for scoring. The sleek design with a rounded head ensures easy handling and movement across game boards.

Purpose

The primary use of this scoring post is to serve as a marker on cribbage boards or similar game scoring systems. It fits perfectly into the holes typically found on these boards, ensuring stability during gameplay.

Printing Recommendations

Print the scoring post with fine layer resolution to ensure smooth edges and a clean, professional look. PLA or ABS would work well for this small object, and no supports should be needed if printed with the correct orientation.

Assembly Instructions

No assembly is needed; it is a single piece designed for direct use after printing. Simply print and start using in your games.

Game Board Marker (Scoring Post for Games Like Cribbage)

0.2mm layer, 2 walls, 15% infill