Trying to set the scene in your necromancer lair? Lighten the mood with a giant round pillar decorated with skulls.

The print is supportless

Instructions:

Print the tiles of your choice.

Remove the small supporting pins on the sides.

Print Openlock clips to connect the tiles.

Push one or more Openlock clips into the tiles (depending on the size of the tile 1 can be enough, 2 works best with big tiles).

Connect the tiles together.

I remixed the original tiles adding an Openlock triplex base you can click the tiles together in a limitless configuration of your choice. This way you can build the terrain easily and don't have to be scared the tiles get pushed around.

I added aditional beams, because I found that printing the big ones without them gives a very bad texture at the bottom. And if I put the time and money in tiles, I want them to be pretty and sturdy.

I also made the tiles bigger, and without a border to make the room more open and added the altar to a skull tile to fit into the Openlock system.

Necropolis tile - big round pillar

big round skull pilar

0.2mm layer, 2 walls, 15% infill

Originale