I wanted another vinyl gloves box to put on my tool box... the ones I found were to small and did not have any magnets to mount on my box! so found Peter Davis @WLHSTechEd_1309681 and used OnShape to cut it and add a 14mm width to it to fit my box gloves also !!

The new holder fits up to 122 x 72mm and the magnet can fit up to 20mm (the set is 20.5mm but depending on your printer tolerances and filaments (I used PETG) and CA glue.

I printed mine w/out supports, I uploaded a pictures so you can see what it looks like. I wanted to save on filament since it's ending up in the garage on my toolbox, so I did not fully care that it was not perfect!!!

"V2"_ VERSION (12/28/25):

- my magnets were not strong enough to hold on to the box with the gloves in them and the weight of my hand... was not sure if it was that my magnet was sitting just a tad below the surface of not...

-- "ORIGINAL" has a depth pocket of 2.4mm

-- "V2_2.3mm SINGLE MAGNET" I reduced slightly the magnet holder to 2.3mm

-- "V2_4.7mm DOUBLE MAGNET" I made the pocket for the magnet deeper

- To help decide which one fits your 20mm magnets I uploaded the "TEST" ring so you can give it a try... if you do like mine, I will add CA glue on top of the magnet so I don't have to reprint it and just print the "test ring" to cover the side...

- p.s.: I also removed the "M" logo on the V2 versions since it fits any size gloves box...

Nitrile Vinyl Gloves Magnetized Box Holder

0.2mm layer, 2 walls, 15% infill

Originale