Dildo with a ribbed shaft, please your hot hole, you won't regret it.

contains two files 3MF and STL

Filament Type: TSS (Thermally Stable Supports)

Extruder and Bed Temperature:

Extruder Temperature: 230-250 °C

Bed Temperature: 80-100 °C

Print Speed:

Printing Speed: 30-60 mm/s

Cooling:

Fan Speed: Minimal or no cooling during print

Layer Height:

Layer Height: 0.1-0.2 mm

Adhesion:

Adhesion Method: Use glue stick or a suitable adhesive spray to ensure proper bed adhesion.

Other Tips:

Storage: Store TSS filament in a dry place with desiccant to prevent moisture absorption.

Calibration: Ensure the nozzle height and bed leveling are properly calibrated for optimal results.

Software Profile: Utilize specific profiles for TSS filament in your slicer software, such as Cura or PrusaSlicer, if available.

By following these settings, you will achieve the best print quality and performance for models made with TSS filament. Happy printing!

If you use pla material, use a condom

Layers (Layer Height): 0.2 mm for a balance between details and printing speed. Print Temperature: 200-220 °C, optimized for PLA material. Bed Temperature: 50 °C for better adhesion of the model to the bed. Print Speed: 50 mm/s for stable and quality printing. Infill: 15-20% for sufficient model strength. Supports: Use supports only where absolutely necessary, such as under recesses or protrusions. Cooling: Enable cooling to minimize deformations during the printing of smaller details. Ensure that these values are adjusted to your 3D printer specifications and make adjustments as needed.

RIBBET SHAFT DILDO