I designed this phone grip holder designed for videography because i simply couldn't find one like this. This is designed for 6.1 inch phones like most of the iPhone series. iPhone Pro Maxes or iPhone Pluses will not fit, including the iPhone 16 lineup.

This model also features cutouts for your buttons so that it doesn't annoyingly get pressed and held down. You may find one of the holder parts to be lower, but that's simply just so your phone's buttons don't get pressed down upon sliding the phone into the phone grip holder.

Talk about sliding, this model is only just a slide-in, slide-out, while still being able to hold your phone tightly to the point i guarantee you that it won't fall out when you rotate it upside down. Though, THIS DEPENDS ON HOW YOU SCALED IT AND THE ACCURACY OF YOUR 3D PRINTER AND I AM NOT RESPONSIBLE FOR DAMAGES CAUSED TO YOUR PHONE!

So, no more "Does this fit my phone?" questions. Just look up your phone and find the scale. If it's 6.1 inches, you're good to go!

Printing details:

Supports: Yes (Tree Slim Supports, 0.25mm Z-Distance)

Speed: 300mm/s, preferably 150-200mm/s (FOR K1/K1C/K1 Max)

Travel Speed: 500mm/s (FOR K1/K1C/K1 Max)

Initial Layer Speed: 60mm/s

Acceleration: 20,0000mm/s² (FOR K1/K1C/K1 Max)

Build Plate Adhesion: None

Printing Material: PETG

Hotend Temp: 260 Degrees Celsius

Build Plate Temp: 80 Degrees Celsius

Infill: 20% (ANYTHING AT LEAST 5% HIGHER THAN 15% IS GOOD!)

Walls: 2

Assembly Needed: No, only take off the supports.

Slide-In Videography Phone Grip designed for 6.1-inch phones

0.2mm layer, 2 walls, 15% infill