Uploaded and printed an awesome complete Router Jig for my Dewalt palm router DCW600 that I adapted from a Ridgid one (you can find it here: )

But it was missing handles to operate the jig so I found a set that takes 2 1/2" hex bolt 1/4-20" thread with a nut... I used Stainless Steel to make sure they don't rust in my truck or my garage.

Made by Joe3020 @Joe3020_295265 at https://www.printassss.com/model/1229844-handle-for-14-20-bolt/files

--- It's 4" tall and 1" diameter handle - a 7/16" nut can fit through

I used PETG for it's durability and also flexibility. Threaded the nut on the bolt and hammered it gently into the top of the handle until it sat flush in the handle, then removed the bolt and placed it underneath where it belongs.

0.4mm nozzle on my Ender 3 V3 Plus, black CR-PETG from Creality and settings at 0.3mm (yep!! print so much faster!!) and 0.4mm wide with a brim of 0.5mm AND I did some support on the outside on four side to help it stay put the whole way since I have a bed slinger!!! I just use the painter tool to place the anchor about 3/4-1" from the base and it worked great!!!

- 3 walls for rigidity 1.2mm bottom (that's the holding power) and 1mm top for sturdiness then infill at 15% Adaptive Cubic.

Printed like a charm!!!! ; )

Tool Handle Bolt 1/4-20" Thread

0.2mm layer, 2 walls, 15% infill