You get a complete Airsystem for the K2Plus with an perfect fitting Poopslidesystem in different Variations.

The whole System adds just 70mm behind your Printer and is mounted with magnets. I designed this, because i have my K2Plus in Kitchencabinet which is limited in depth. On the Top there is an Adapter to a 100mm flexible Tube for Exhaust-vent.

The whole System is spaced to let normal Aircooling take place and give middle Chamberheater enough room to soak air.

Poopslide System is tested with over 100h in ABS and PLA print, no clogging at all.

Variation 1 Airsystem:

Whole System adds 70mm behind your printer.

Variation 2 Airsystem:

Two additional elbows with fullsize diameter, this adds 100mm behind your Printer, but has fullsize Ventilation.

Variation 1 Poopslidesystem:

One Adapter magnetmounted to the Poopshute of your K2Plus and a Slide which bends as near as it can to the back of your Printer and til the bottom.

Variation 2 Poopslidesystem:

One Adapter magnetmountes with a straight Poopslide for Tablestand.

Plus a Drawer, which can be used on a Table just stand under the Poopslide Variation2 OR with a Slidemount to be mounted outside of the Cabinet with Variation1, ALL see Pictures.

Additional Material you need is:

28x Magnet 6x2mm

26x Magnet 10x2mm

100mm Hoseclamp

100mm Hose for Ventilation in desired Length.

2x Countersunkscrew 4 or 4,5mm (This you need just for Drawermount on the Sidewall of a Cabinet).

System was tested before with 4x2 and 6x3 magnets, but this wont give enough mountingforce, therefore added 10x2 magnets. these are supplying enough mountingforce now.

Printing info:

My goal in designing is perfect printing experience, without supports and hard problems.

Most parts can be printed without supports, but a little treesupport is need on the poopslide-adapter, use 2 walled trees there.

On the Y-manifold you have to use supports at least for the flange lowerside, also use 2 walled treesupport.

Update 02/2025:

Poopslidesystem added for the other side (New Parts: Flange, Slide and Drawer). If you have bought already, just login and download the parts agein, for free! No additional payment needed. Have Fun and ask for help, if you are having problems or want additional parts.

Additional Info 03/2025:

The Y Manifold just connects to the back of the printer with the two lower magnetmounts. the upper magnetmount is about 100mm above your printers backside. if you have the cfs standing on top of your printer, just put a magnetic steelplate with doublesidedtape on the back of your cfs. whether you dont have your cfs ontop of your printer, you have to add a steelplate with double sided tape on the back of your printer to ensure the needed height for mounting the top holder. but if you add a hose to this system, the magnets can't hold the weight of the hose, so better mount the hose right, then it gives stability to the whole airsystemmount to! i also reccommend doubletape the system with vhb to your printer.

K2Plus Airsystem with Poopslide magnetic