**Update**

For the K2 Pro version use this link.

K2 Pro Riser

Please go give a 'like' to the original designer Abernus using the link below. I found this K2 Plus lid riser and loved it's simplicity and sharp look.

https://www.crealitycloud.com/model-detail/679229ccb0f06136c737a6c1?source=5

In the end I remixed it because I had some trouble with support removal. Though the rough edges were not really visible, they still bothered me. I also didn't want to find out later on that it had gouged/scratched the top due to vibrations. So, I added a chamfer to the bottom edges of all of the perimeter riser pieces. The sliding vent pieces are unaltered. This will change the look slightly, but it still fits fine and I think it still looks great.

With a clean bed between each plate/print I was able to print with Creality Hyper-PETG (Gray and Green) with no brims, rafts or glue. So the reduced surface area has not seemed to be a compromise print quality.

*These are for the tighter tolerance models only. I've made no adjustments to the loose tolerance pieces.

Abernus K2 Plus Lid Riser w/Chamfered edge

0.2mm layer, 3 walls, 10% infill

0.2mm layer, 2 walls, 15% infill

オリジナル

リミックスモデル