Description

During the use of the printer, new tools and parts appeared - hence the need to make a second box. I did not expect that my previous box would gain such great popularity - hence the desire to improve/streamline it. I wanted both boxes to be compatible with each other, so I did not create new solutions but based on what had already been created. The first change is the installation of magnets that improve the stability of the drawers and at the same time, small tilts will not cause them to be accidentally pulled out. The second modification is an arbitrary configuration of two smaller drawers.

Printing

To correctly print the drawers and part of the box, you need to pause printing in the right place and mount the magnets.

I bought neodymium magnets in the size of 10x10x3mm (circular shape).
In the slicer, you need to set a pause on layer 68 (0.4mm nozzle - 0.2mm profile) - file: magnetic-tool-box-M2.stl. If you use a different profile - set the pause yourself on a different layer. When the printer stops - you should insert magnets into specially prepared places (insert them all the way so they don't stick out). You can use a small amount of cyanoacrylate glue - but it's not necessary. After installing the magnets, you should start printing again.

ATTENTION!
It is important not to confuse the polarity of the magnets - those in the drawer must be attracted to those in the housing - a mistake will result in the opposite effect to the intended one and the drawer may slide out slightly :D
The second element in which we use pause and magnets is the file: magnetic-tool-box-obudowa-sciana-tylnaa.stl. In this case (nozzle 0.4 - profile 0.2) the pause should be set to layer 250. We print this element "on its back" so that both walls stand vertically.

Assembly description

Basically - apart from the assembly of magnets during printing - the assembly of the box itself is exactly the same as in the case of its earlier version:
https://www.crealitycloud.com/model-detail/677ac60c06c912fef1ed6579?source=22
so I won't write the same thing again.

I added a Roman numeral 2 in the letter "C" and printed it in reverse colors so that the boxes wouldn't get confused, but I think that using the same colors with this Roman numeral 2 will also do the trick.

And finally the drawers. As I mentioned, the two smaller ones can be configured to suit your needs.
Małe szuflady wydrukowane są jako jedna przestrzeń ale dodałem osobno przegrody (magnetic-tool-bpx-przegrody.stl) i można dowolnie podzielić sobie przestrzeń. Przegrody należy dociąć przy pomocy noża lub piły a następnie wkleić na rz\dki klej cyjanoakrylowy. Nie nalezy przejmować się drobnymi niedoskonałościami dopasowania :)

Filamenty:
czarny - PLA
zielony - SILK-PLA
biały - PLA

Miłego pobierania i składania :)

K1C magnetic tool-box

0.2mm layer, 2 walls, 15% infill