This is the second version of the microphone of the mermaid princesses from Mermaid Melody.

( I rendered the pearl blue because my favorite is Hannon, but you can paint the pearl any color. )

The microphone is about 300 mm long and is split into two parts to fit an Ender 3.

It has a hole in the middle so you can put a stick as a skeleton.

I also provide a rod, but if you want to place an aluminum rod.

From personal experience, printed rods end up breaking easily. That way, you can use a 4mm aluminum rod (it can be circular or square. The hole is square, but 10 mm rods will fit.)

For a PLA printer advice these settings:

Quality: 2.8

Walls: 2 or 3

Infill: 10%

Pattern: Zig Zag

- May need some small supports

-I don't like to make vertical cuts because the circular parts never look good ( in my opinion. ) But if you want I can cut it in another way )

-It also provides the entire microphone (without being cut and without a hole) so you can cut it however you want.

If you liked the model, please click on like and rate. It is very important for me to know that they like my models. If you have any suggestion or doubt, do not hesitate to ask. :)

You can whenever you need to send me a message here or on my Instagram. @3d.titi

Mermaid Microphone ( second version ) - Mermaid Melody