Wyze Vacuum S Wall Mount

https://www.thingiverse.com/thing:6413048

This is a remix of ciruittree’s wall mount.

https://www.thingiverse.com/thing:6221315

Summary

FITS THE WYZE CORDLESS VACUUM S (yes, the one from Wal-Mart) & WYZE CORDLESS VACUUM

Recently bought the Wyze Cordless Vacuum S only to realize that it didn’t come with the Wall Mount that the previous model had come with. Luckily, I still had that one lying around so I broke out the digital calipers and a few moments later in Tinkercad we had a like factory model.

NOTE: For removing the supports under the "hook" I just slid my scraper tool under and rocked side to side until I was able to detach the base, and then did the same to the angled portion and it all came out clean. Removing the supports from the Cable Holder took some doing, just be patient so that you don’t tear it off. I may re-upload at some point and try and better support this area later on. (I used my "cutting pliers" to grab ahold of the supports and rip it out of the area)

ENJOY!

Changes:

thickened cord retainer attachment
strengthened hook
removed some non support walls to save filament
added an additional section that "captures" the bottom vacuum hinge.
- this is mostly for bump protection to help keep the stress off of the hook when bumped (mine is mounted in a tight laundry room and is bumped into easily).

Notes

My changes were quick and dirty and may not be perfectly symmertical / fix model issues / etc. It prints fine, but is not going to win any awards.

Print Settings

Printer brand:
Creality
Printer:
Ender-3 S1
Rafts:
No
Supports:
Yes
Resolution:
Standard
Infill:
15%
Filament brand:
Any
Filament color:
Any
Filament material:
PLA

Wyze Cordless Vacuum S Wall Mount

Original