This is not my design! The design is by rreit on Printables.

Link to site:

https://www.**********.com/model/804221-annoying-gift-box

Annoying gift box

It's annoying gift box with inner size 16x8x16 cm ( I build it for headphones). Also there is 74 screws and driver under the “crown” (yes it's ribbon i know). I printed it on 0.15 layers but it probably fine around 0.2 0.25. Everyting is printed with PLA.

Build instructions

You basicly have 2 options harder and easier, there is 74mm and 148 mm screws that fill secure bottom lid to base box. The 148mm are kinda difficult to screw and i needed to use lube for them.

put bottom lid on the base box and secure it with 74/148mm on 4 sidex
cover it with top lid until you hear “pop”
secure top lid with side panels
screw everything in this order:
- 8mm 1.25 is for smaller side panels
- bolts 10mm 1.25 no cap is for larger side panels
- side bolts 20mm hex are for every 3rd hole on side panels from sides (4 on each)
- side bolts 20mm rounded are for every 2nd hole on side (3 on each)
- bolts 10mm 1.25 cap are for securing top and bottom lid together
lastly place screwdriver under the crown and screw crown in (it has reverse thread)

Annoying Gift Box

0.2mm layer, 2 walls, 15% infill

0.2mm layer, 2 walls, 15% infill