VERSION 2 OF SHENRON IS A SEPARATE FILE. THIS VERSION NO LONGER RECEIVES UPDATES.

The model will be for sale ONLY and found on the following pages. It will not be uploaded anywhere else.

https://www.printables.com/@zuperbuu_1527797

https://cults3d.com/en/users/zuperbuu/3d-models

https://www.crealitycloud.com/user-profile/1399948366

https://www.patreon.com/thomastedwards

THE 3MF FILE MAY ONLY OPEN IN BAMBU STUDIO.

To open in other slicers, use the RAW STL files. These files don't have paint data on them, however.

This Shenron model comes in two sizes; short, and long. The short dragon has 12 joints down its body, the long has a whopping 31 joints!

The whiskers are just strips of filament that I have glued into the holes on the side of the muzzle, a filament size of 1.75mm fits in the holes nicely.

I printed mine without a brim; providing your hotbed is clean/freshly glued, you shouldn't need a brim either. If you find you have adhesion issues though, I would suggest giving it a brim.

Supports are not needed for this model; do not use them or the model can break when you remove it from the supports!

All my prints were done using PLA filaments from a wide range of brands. A few are by eSun, Sunlu, Eryone, Prusament, Bambulab, and Gratkit.

Be aware that the long version of the model can get VERY close to the plate edges, so you won't be able to make this model any larger. I wouldn't print it any smaller as the joints will likely lose strength.

The joints can move in almost all directions, though the hips have the least movement. The arms and legs do not move.

You can see the range of movement in the video below:

https://youtu.be/gyW1gvRe94c

This file covers personal, non-commercial use; do not share or redistribute without attribution. Do not sell the files or prints of the files. Remixing is allowed but again providing attribution is required.

If you want to sell prints of this model, please visit my Patreon to learn how to obtain a Commercial License: https://www.patreon.com/thomastedwards

Articulated Shenron Dragon Toy v1

0.2mm layer, 2 walls, 15% infill

0.16mm layer, 3 walls, 15% infill

0.2mm layer, 2 walls, 10 infill