Created this 5015 Fan adapter for BentoBox Slim for Creality K1 Max. I printed this using PETG-CF, I have not tested this on other filaments however I suggest printing with a high temp and dimensional accurate material.

Disclaimer: I am not responsible for any fire or damage to your electricity circuit if you mess up the wiring. Do this at your own risk or ask someone who knows how to solder.

The following are the other parts you will need:

M3x20mm screw x 4 - https://www.amazon.com/dp/B0C7ZPZ214?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_3&th=1

M3x20mm screw, nut, and washer - Same link as above

4x2mm magnets(optional but highly suggested) - https://www.amazon.com/dp/B09SKWWMVM?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_7

M3 heat inserts - https://www.amazon.com/dp/B0CS6VZYL8?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_1

5015 fan x2 - https://www.amazon.com/dp/B0886BQRX4?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_1&th=1

Switch (optional) - https://www.amazon.com/dp/B08TBZ23C1?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_3

12v Power supply (with plug) - https://www.amazon.com/dp/B07VQHYGRD?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_1&th=1

4 pin extender(optional - but you will need to extend the side fan with other wires) - https://www.amazon.com/dp/B0DLSL74CC?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_1

See documentation how to assemble.

BentoBox Slim 5015 Adapter for K1 Max

0.2mm layer, 2 walls, 15% infill

Original