UPDATED VERSION !!!! if you downloaded my model before 2024-05-11, I would suggest to download updated version . First version was made in free cad. Now I'm trying fusion 360. I don't have a picture of the updated back feet because I'm using old version still (they look similar to old version just added fillets instead of chamfers), just replaced the front feet (you can use all 4 smaller feet if you want, that will save you around 100g of filament). I wasted enough plastic on this project. If you decide to make or already made a motherboard fan mod, don't worry, there is enough clearance for that(last photo).

These new front feet are even more stable and prints in one piece. Also raises the printer by almost 5cm compared to original feet. Back feet prints in two parts . After printing you have to screw them together with two M2 heat inserts and two M2-20 screws (you can glue them if you want) and repeat for the rest. Order some anti vibration pads from ali express , size 10x10x2 cm , They are being sold in packs of 4 and they cost around 1-2 euro with discounts.

After everything is finished, just place the original printer feet inside the socket on the bigger feet and that's it.

Printed with PLA

20% infill Supports: YES (for the front) , NO (for back ones) 4 walls 3 top and bottom layers. Support density 15% (because normal supports on creality print 5.0 is 100% density, I sliced with 4.3 version to get that option. 100% needs to much filament and adds 2 hours on the print time.)

Tip: You can set layer height to 0.3mm for faster printing. Slow down the speed when printing bottom layer on the front feet and slow down the speed when printing top layers on the back feet to get good results.

Big feet for Ender 3 v3 KE (UPDATED VERSION)

0.2mm layer, 3 walls, 15% infill

0.2mm layer, 2 walls, 10% infill

0.2mm layer, 2 walls, 15% infill