Updates

[20240524] Rev. D has been replaced by Rev. E: a rib was added because the guide was too fragile.

Intro

This cable clamp guides the ribbon cable not only upwards but also straight backwards. This means the printer takes up less space. It fits both SE and KE models of the Ender-3 V3.

Properties are:

The clamp does not require any mounting material and detaching of printer elements. It clicks around the left leg of the gantry.
Most of the sharp edges of the holder are rounded (no "Tinkercad" and "Sketchup" angularity).

Information at Thingiverse

For all latest/extra information and recent model see also https://www.thingiverse.com/thing:6449199.

Print Settings:

Printer brand: Creality
Printer: Ender-3 V3 SE/KE
Resolution: 0.2 mm
Wall thickness: 0.8 mm (2 wall lines)
Infill: 15-20%
Filament material: PLA or even better, the more flexible PETG
No support is needed when the setting of the support overhang angle is ≥45° relative to the print bed.
For good adhesion, use a brim of approximately 3 mm.

Post-Printing

Remove the small piece of support for one of the lugs with the cutting pliers.

Cable Clamp for Ender-3 V3 SE/KE (supportless)

0.2mm layer, 4 walls, 30% infill

0.2mm layer, 2 walls, 15 infill

0.2mm layer, 2 walls, 10% infill