Summary

I made this Cantilever Suspension to remove the rear shock towers so you can have more options for bodies on your Axial SCX-10.

My Main goal was to use the stock shocks to keep the cost down. You will need to print the parts and purchase a couple nuts and bolts. But overall cost is really inexpensive. Plus if anything breaks you can always print a new part!

Here is a list of parts that are needed to complete this project.

Printed Parts:

1 x Base (Added a second base option with larger peg holes for the "Mount Left and Right" if you print is too tight)

1 x Mount Left - Glue to "Base" part

1 x Mount Right - Glue to "Base" part

2 x Pivot 1

2 x Pivot 2

2 x Spacer 1

2 x Spacer 2

Bought Parts:

2 x M3 40mm bolt

2 x M3 nut

4 x M2 16mm bolt

4 x M2 nut

(you can use M3 bolts and nuts instead of M2, you just need to drill the holes a little bigger)

Bought or made Part:

2 x Push rods 28mm long from center of ball joint to center of ball joint

--- For the Push rod (the connection between the cantilever itself to the axle), I used the extra rod ends that you get when you buy a SCX10

This thing was created by Thingiverse user RMTCTRL, and is licensed under Creative Commons - Attribution - Share Alike

Cantilever Suspension for Axial SCX10

0.2mm layer, 2 walls, 15% infill