An ADD-ON to the 3 CFS or 2 CFS stand
https://www.crealitycloud.com/model-detail/3cfs-stand-sliding-rails-non-overturning

https://www.crealitycloud.com/model-detail/2-cfs-stand-sliding-rails-non-overturning

by d_v_ermakov ( https://www.crealitycloud.com/user-profile/2015296294/models )

This guide prevents the CFS PFTE tube or cables from getting trapped on the back frame as the CFS drawer is slid in and out.

My tube and cables have a natural drop and were getting pinched on the frame. I designed this "platform" to slide under the CFS and above the drawer frame. The 2 angled guides help to push up the platform as it reaches the printer and guide it into place as the platform is thin and has, or could have, some sagging over time.

I printed in PETG-CF as I already had it loaded for the 3 CFS Shelf parts, but PLA should work just as well.

There are 2 different platforms as the bottom shelf frame is lower than the drawer. The middle shelf is at the same level as the drawer.

You will need (8) M4-8mm screws and (8) M4 t-nut for V2020 to mount on the 3CFS shelf.

If you are using just the "bottom" platform on a 2 CFS, you just need (4) of each.

3 CFS Stand ADD-ON - PFTE-Cable Support

0.2mm layer, 4 walls, 15% infill

0.2mm layer, 2 walls, 15% infill