Disclaimer: AI was used to change the printer's background. However, the picture is of the actual printed models. They were not changed in any way from the original picture.

Fits the K2 PLUS printer. This is a remix model of a CFS riser to make it fit another model of a top glass riser + ventilation. Link to both models:

- CFS Riser:

https://www.crealitycloud.com/model-detail/k2-plus-cfs-riser-lid-plate-storage?source=5

- Top Plate riser:

https://www.**********.com/model/1294778-k2-plus-riser-for-top-plate

Changes were made to the CFS Riser model exclusively:

- Notch was added for tolerance relative to the top plate riser

- Added 5 cm of length to the legs

- Removed ~3mm of extrusion on the side so the legs are flush with the printer's side panel

The original models' features are as follows:

- Slider for ventilation on the top glass

- Notches to store one extra build plate and the top glass right below the CFS

BOM

You will need in total 20 M3 x 8 mm screws to assemble the top plate riser, as well as some anti slip feet for the CFS riser (I used double sided tape; TPU squares would also work well). They are only to keep the legs from sliding back and forth

If you like this model, please post a picture of your setup and check out the original creators' work

CFS + Top Glass Riser for K2 plus - All in one solution

0.16mm layer, 3 walls, 15% infill

Original