This is my first design, I used Solidworks "XDesign" to make this.

It's a throttle lever replacing a broken lever on my CH Products Flight Sim Yoke. I printed the black ones (Pictured on the controller without knobs) using ABS Hyper @ 40% infill Gyroid.

K1 MAX took 5'ish minutes to print.

No Supports, No Brim, whatever infill and filament you want to use, I used ABS for the main product. PLA for prototyping. I Included STL and 3MF exported from XDesign.

Just orient the flat back onto the plate. I always recommend a skirt.

The original throttle levers had two different heights (one was 10mm taller), but I printed and replaced all three the same size and it fit, no problem. The original knobs also fit if you want to use them. (I will post the knob I made in another post, I just gotta wait for them to cure after their acetone vapour bath so I can install them)

link to the knobs



This is a very tight friction fit, no glue is needed. The knobs also fit really tight.

*Note, If you are replacing the center lever, you might need to desolder the potentiometer*

Happy flying, racing or whatever you do with it!

CH Products Flight Sim Yoke Throttle Lever

0.2mm layer, 2 walls, 40 infill

0.2mm layer, 2 walls, 15% infill