Bedside Organizer – Wall Mountable

A simple, convenient bedside organizer designed to hold two remotes and your phone.

This organizer can be easily wall-mounted using two standard drywall screws.

It features a built-in hole where your phone rests, designed to snugly fit a Type-C or iPhone charging cable—keeping your device charged and accessible.

*Note: not all cables are the same and some maybe thicker or thinner. With that being said you can simply hot glue the cable in place if its too thin or File/Dremel the hole larger if it's too small.

This should fit any phone with a case on or off. Android or Apple.

If you have any changes or design improvements feel free to let me know and I will happily try to improve and make new versions.

Printer Info:

Printed on Creality K1C

Sliced on Creality V6.2

Filament: ****** PLA + Black

Extruder: 4mm 220°C

Bed: 50°C

Fans: Model 95%, Side 85%

Supports: none

Walls: 4

Infill: 5%

Top Surface: Mono

Bottom Surface: Mono

Other:

Slow for curled perimeters ON

Precise Walls ON

Mount the Holder:

1. Place a piece of tape across the back of the model, covering the mounting holes.

2. Mark the hole positions on the tape.

3. Remove the tape from the model and place it on the wall or surface where you want to mount the holder.

4. Drill small pilot holes at the marked positions.

5. Insert screws into the pilot holes, leaving the heads slightly protruding.

6. Align the holder with the screws, slide it into place, and press down gently to lock it securely.

7. Feed the end of your charging cable through the hole from underneath. The fit should be snug to hold the cable securely. Once the tip of the charger is visible above the surface, place your phone in position on the stand. Then, gently push the cable upward until it connects properly with your phone, ensuring the charger sits at the correct height.

Charging Phone Holder with 2 Remote Slots

0.2mm layer, 4 walls, 10% infill

0.2mm layer, 2 walls, 15% infill