Have you ever thought: "This lollipop is so hard to twist", but also: "Where do I put it"? Well, you are in luck, because I've decided to fix this niche problem I had by over-engineering simple Chupa-Chups holder. This creation solves 3 things:

1)Helps you to twist it while eating lollipop to ensure full candy coverage on all sides and prevent fingers slipping
2)Blocks the air intake greatly reducing air sipping and reducing noise
3)Doubles as a stand, when you need to temporary place it somewhere without it getting all messy

How to use:

Screw cap into a base slightly to hold them them together, insert candy on a stick of your choice all the way and start tightening cap until it holds your candy securely, you do not need to tighten it all the way, just enough so it holds it snug.
After finishing candy unscrew slightly and remove stick, no need to separate them completely
If cap piece gets damaged after use of jaw piece broke off - reprint cap piece, base should be almost indestructible.
After first print screw pieces together completely and unscrew several times until it screws freely.

Why:

Chupa-Chups is one of my favorite candy of all time, but some things are really annoying to deal with. Even tho it is on the silly side of things, I do really enjoy using it as it helps to fix one of my main problems with it - twisting. Other 2 things are a nice bonus to have, but were not intended originally. I should mention that it is reusable, when you are done - simply unscrew cap slightly to release stick and you are ready to load next one (Don't eat too much of them, sugar is not good for your teeth)

Also haven't tested it, but in theory should work for holding any straight stick-like object with diameter from around 3mm up to 4.8mm, but for secure fit only around 3.5mm to 4.8mm.

Print settings:
2 Walls
15% infill of your preferred type (You CAN go lower for sure, but haven't tested it)
Support: Cap needs support for handle part, threads are fine without them, but if you want to be on a safe side - print with auto supports, they are somewhat tricky to get out.
Any material will fit, but suggest PLA

Chupa-Chups Holder (Or almost any lollipop on a stick)

0.2mm layer, 2 walls, 15% infill

0.2mm layer, 2 walls, 15% infill