Detachable magnetic front panel. for K1 ,K1 SE

This front panel was designed in this manner because a certain degree of strength was required.

You will need to print both, Magnet Frame and the Magnet Front Panel.

All models are printable in K1.

Side Panel :

https://www.crealitycloud.com/model-detail/creality-k1-k1c-k1se-enclosure-side-panel

Top Cover :

https://www.crealitycloud.com/model-detail/creality-k1-k1c-k1se-enclosure-top-cover

You need print below lists and prepare magnets,screws.

1.Magnet Frame

・UP_RIGHT.stl x1

・UP_LEFT.stl x1

・BOTTOM_LEFT.stl x1

・BOTTOM_RIGHT.stl x1

・CONNECTOR.stl x3

・CONNECTOR_BOTTOM.stl x1

・Neodymium magnet φ20mm x 2mm x8

・M3 screw 6mm x 8(socket head cap screw)

Careful:Using long screws may cause collision with the extruder.

2.Magnet Front Panel

・panelA.stl x1

・panelB.stl x1

・panelC.stl x1

・panelD.stl x1

・panelE.stl x1

・connector_v x2(To ensure strength, please print in the direction shown in the photo. Support is required as necessary.)

・connector_h x2(To ensure strength, please print in the direction shown in the photo. Support is required as necessary.)

・magnet_seal x4(option)

・Handle_XLARGE.stl by Mohd Zainol B Buyong (https://www.crealitycloud.com/model-detail/all-purpose-handle?source=5)

・Neodymium magnet φ20mm x 2mm x8

・M3 screw 10mm x 4(socket head cap screw)

・M3 screw 12mm x 8(socket head cap screw) for connector

・M4 screw 12mm x 3(socket head cap screw) for handle

Others:

Double-sided tape is useful to attach magnets.

To avoid noise caused by printing vibration, good for using foam tape.

Creality K1,K1 SE Enclosure : Magnetic Front Door & Frame