I've designed a lighting mod for the K2 Plus that fits perfectly into the original light's mounting holes. The factory lighting is often not bright enough, especially with tinted doors. This mod doubles the size of the lighting setup, greatly improving visibility and making it easier to see objects clearly.

You’ll need 5mm COB lights rated at 24 volts, with a length of at least 2 feet. I always like to buy extra in case of mistakes or for future projects, it’s better to have a bit more than to run short!

You'll also require a couple 1.25mm micro JST 2 pin connectors and 6 M3x8mm screws for mounting.

Assembly:

1- Trim the LED strip to match the length of the printed holder, ensuring you cut only at the designated cut zones on the strip.

2- Peel back approximately 1 inch of adhesive from the back of the LED strip to reveal the connectors. Solder a JST 2-pin connector to the back of the strip, then reapply the tape over the connection to secure it.

3- Insert a screw through the front of the mount and thread it into the standoffs located on the back of the printed light bar, ensuring the cup faces outward.

4- Remove factory lights, replace with new brighter ones.

AliExpress - 5mm cob lights 24 volts - https://a.aliexpress.com/_mqxoCcL

Amazon - 1.25mm micro JST 2 pin - https://a.co/d/eJSJPfB

Please don't forget to leave a like, Thanks

Creality K2 Plus Light Strip Mod

0.2mm layer, 3 walls, 100% infill

0.2mm layer, 2 walls, 15% infill