🧠 DeWalt 20V Battery Mount with ID Cards

A compact wall or under-shelf mount designed to securely store DeWalt 20V batteries while keeping them clearly labeled with removable ID cards.

This mount uses a snap-fit battery interface and includes a set of slot-in ID cards so you can quickly identify battery/slot number.

The design also features the Hyperion Creations Breakaway Support System (HCBSS) to ensure a reliable print with minimal post-processing.

🔧 KEY FEATURES

🧱 Wall or Shelf Mount
Mount vertically on a wall or horizontally under a shelf to keep batteries organized and off your workspace.

🔒 Secure Snap-Fit Hold
Designed to match the DeWalt battery rail geometry for a snug, reliable snap-in fit.

🪪 Slot-In ID Cards Included
Includes a set of ID cards that slide into the recessed label slot for quick battery identification.

💡 Hyperion Creations BREAKAWAY SUPPORT SYSTEM (HCBSS)

This model utilizes a CAD-engineered sacrificial support system designed directly into the model geometry.

Instead of relying on slicer-generated supports, the print includes precision breakaway support structures that:

• Ensure reliable bridging during printing
• Prevent sagging inside recessed areas
• Break away cleanly with minimal surface scarring
• Eliminate the need for slicer supports

Simply remove the supports by hand after printing.

Note: An .stl file of the mount is also included if you would rather utilize your own supports or slicer settings)

🖨 PRINTING RECOMMENDATIONS

Material:
PLA or PETG recommended

Layer Height:
0.20 mm works well

Supports:
No slicer supports required - (HCBSS is built into the model)

Brim:
Optional

🧰 INCLUDED COMPONENTS

The project includes:

• DeWalt Battery Mount
• Slot-In ID Cards
• Blank ID Card
• Recess Fill-In Insert* (optional)

* The fill-in insert allows you to print the mount without the ID card slot if desired and still install it securely.

🧩 ASSEMBLY

Barely any assembly required to install.

Simply:

1️⃣ Print the mount
2️⃣ Remove the breakaway supports
3️⃣ Print an ID Card or Fill-In Ring
4️⃣ Insert your preferred ID card or ring.
5️⃣ Screw the mount to the installation location

📌 NOTES

This mount was designed around DeWalt 20V style battery rails including Power Stack.

Fitment may vary slightly with third-party battery packs depending on rail tolerances.

⚙ DESIGN PHILOSOPHY

Like all Hyperion Creations models, this design prioritizes:

• Reliable printing
• Practical workshop use
• Thoughtful engineering details
• Minimal post-processing

📝VERSION INFO

📌 v1.0 – Initial release designed as a battery mount with ID Cards.

🔮 Future variations may include additional ID Cards if there is enough interest.

💬 Suggestions and improvements are always welcome — and as always, photos of your prints are appreciated.

Thanks for checking it out, and Happy Printing!

DeWalt 20V Battery Holder Wall Mount w/ID Cards

0.2mm layer, 2 walls, 15% infill

0.2mm layer, 2 walls, 15% infill